Siemens LMV27.100x2 - 26.11.7 Cold settings for G mod pneu, Gp1 mod pneu and Gp2 mod pneu

169/219
Building Technologies Basic Documentation LMV27... CC1P7541en
26 Parameter level 17.12.2018
26.11.7 Cold settings for «G mod pneu», «Gp1 mod pneu» and «Gp2 mod
pneu»

Note
Refer to chapter Warm settings for modulating mode («G mod», «Gp1 mod», «Gp2
mod» and «Lo mod»)! With no flame, however, no actuator travel and no automatic
operation after the settings have been made. Here, only the air requires adjustment
with
A
.
If run is shown in the display, the following must be observed:
P
Vh
mi n
s%
Bild 113/0707
Identification of start for setting the curve.

Note!
You now have the option of pressing
ESC
to continue with the cold setting for
the LMV27.