Changes to previous version
MAMMOMAT Balance SPB7-115.840.01 Page 62 of 62 Siemens AG
Troubleshooting Guide Rev.02 10.04 Medical Solutions
Changes to Previous Version
Chapter Page
Change
Control LEDs 8
... bright fix during grid movement.
Control LEDs 8 Filament power supply PCB 92-073
Operating Errors On
Display
16 NOT ACTIVE
Technical menu;
Rotating anode
92-074 >> FAIL <<
19 …of jumpers on CN5 PCB 01-170 or flat cable CV0174.
Picture changed
Technical menu;
Inverter
20 Led DL1
...of Jumpers on CN3 PCB 01-170
Picture changed
...Vdc (in)= 000 then F3 of PCB…
Technical errors in
LOG file
20 Better text and images to download last 1300 events from mammo
List of Error Codes 22 NOT ACTIVE
Calibration of
protection circuit
23 Picture changed
Anode current
calibration
29
To enter mAL current calibration set DIP2 of SW1
Accessing the
program
39 Creation of a new Dosemeter file removed: change in text and images
Radiation table 43 ... in a "kV" versus reference dose grid. Any row…
Dosemeter
configuration
45 Picture of Dosemeter configuration window changed.
Dosemeter
configuration
46 ... display pushing, in Manual Mode, the BELL…
FOCAL SPOT DISTANCE
Introduction 51
…refer to Operator’s manual SPB7-115.620.01…
Configuration of
maximum
compression force
51 ... correction factor from 1 to 20 that will…
Brake force
adjustment
52 Better text and image
To Previous Page
Loading...
