Siemens MD-P1 - Supported P1 Applications

1
Supported P1 Applications
MD-P1 and MD-P1D Power Meters Wiring Diagrams
30
Siemens Industry, Inc.
125-201
09/30/2019
Supported P1 Applications
The MD-P1 and MD-P1D Power Meters are factory pre-programmed for the following
applications when ordered in a kit with the appropriate current CTs:
Application
Usage
2671
50 Amp CTs
2672
1000 Amp CTs
2673
100 Amp CTs (default for MD-P1x-3-CTSC-100A)
2674
200 Amp CTs (default for MD-P1x-3-CTSC-200A)
2675
400 Amp CTs (default for MD-P1x-3-CTSC-400A)
2676
600 Amp CTs (default for MD-P1x-3-CTSC-600A)
2677
4000 Amp Rogowski Coil (default for MD-P1x-3-RC-xx)
2679
Universal (scaling must be set at the job site)
NOTE:
If an MD-P1 or MD-P1D Power Meter is ordered as a spare, it will leave the factory
configured for Application 2679.
NOTE:
If the P1 meter has firmware earlier than Revision 4.5, the application numbers use a
number that is 100 higher (for example, Application 2671 was 2771). Please update
older PI units to Revision 4.5 or higher to resolve a possible application number
conflict with other sensors.