Siemens Midimaster Eco Reference Manual

ECO REFERENCE MANUAL
13-35
PID PARAMETER SETTINGS
Closed loop process control cannot be used
unless P201 is first set to 001. Most of the
parameters associated with closed loop process
control are shown in the Closed Loop Process
Control figure. Other parameters which are also
associated with closed loop process control are
as follows:
P010
Scaling of display(only if P001 = 1, 4,
5, 7 or 9)
P061
Relay output to indicate when
controller has reached output limits
(value = 012 or 013)
P220
Auto switch off inverter output when
control has reached minimum output
level.

Siemens Midimaster Eco Specifications

General

Brand	Siemens
Model	Midimaster Eco
Category	DC Drives
Language	English