Siemens Midimaster Eco - Table of Contents

ECO REFERENCE MANUAL ADDENDUM
1
CONTENTS
Section 1 1. SAFETY AND COMPLIANCE .........................................................1-1
Section 2
2. INTRODUCTION.............................................................................2-1
PRODUCT DESCRIPTION AND APPLICATIONS ....................2-1
Eco OPERATING INSTRUCTION MANUAL .............................2-1
Eco REFERENCE MANUAL ......................................................2-1
Section 3
3. PRINCIPLES OF INVERTER OPERATION....................................3-1
INTRODUCTION........................................................................3-1
VARIABLE SPEED DRIVES.......................................................3-1
VARIABLE FREQUENCY INVERTER. ......................................3-4
Section 4
4. ADVANTAGES OF THE Eco...........................................................4-1
ENERGY SAVINGS....................................................................4-1
CONTROL & REGULATION......................................................4-1
PID - INTERNAL.........................................................................4-1
NOISE.........................................................................................4-1
WEAR & TEAR...........................................................................4-2
EQUIPMENT RATIONALISATION.............................................4-2
REMOTE (OUTSTATION) CAPABILITY WITH RS485 SERIAL
COMMUNICATION ....................................................................4-2
Section 5
5. TECHNICAL OVERVIEW & PRODUCT RANGE TABLES.............5-1
STANDARD FEATURES............................................................5-1
TECHNICAL FEATURES...........................................................5-2
OPTIONS ................................................ ..................................5-9
Section 6
6. ENERGY SAVING PROGRAM .......................................................6-1
ENERGY CONTROL OPTIMIZATION (P077) ...........................6-1
Section 7
7. PULSE WIDTH MODULATION (PWD) OUTPUT METHOD ..........7-1
SWITCHING FREQUENCY FOR LOW MOTOR NOISE ..........7-1
Section 8
SC
8. Eco SELECTION CRITERIA - SIZE, TYPE ETC. ...........................8-1
OVERALL CONSIDERATIONS..................................................8-1
SUPPLY SIDE REQUIREMENTS ..............................................8-1
SUPPLY TOLERANCE...............................................................8-1
SUPPLY DISTURBANCE...........................................................8-2
UNGROUNDED SUPPLIES.......................................................8-3
LOW FREQUENCY HARMONICS.............................................8-3
MICROMASTER Eco .................................................................8-3
MIDIMASTER Eco......................................................................8-3
EMC FILTER RESTRICTIONS FOR ALL PRODUCTS.............8-3
MOTOR LIMITATIONS ..............................................................8-6
LOAD CONSIDERATIONS ........................................................8-8
VARIABLE TORQUE APPLICATIONS ......................................8-9
OTHER LOADS........................................................................8-10
ENVIRONMENTAL CONSIDERATIONS .................................8-11
IP PROTECTION......................................................................8-11