Siemens Midimaster Eco - Page 59

ECO REFERENCE MANUAL
10-5
Gain Access to Terminals Frame Size C
While supporting the fan housing with one
hand, insert the blade of a screwdriver into the
slot on the underside of the inverter and press
upwards to release the securing tab. Lower the
fan housing, allowing it to swing out to the right
on its side-mounted hinges.
Applying pressure to the gland plate, release 2
clips in the direction of the arrows. Swing the
plate out
H
J
A: Fan housing opening tab
B & C: Gland plate release tabs
D: Control cable input
E: Mains cable input
F: Motor cable input
H
:
Fan connector
J: Fan Housing removal tab
To remove fan housing and fan disconnect fan
connector ‘H’, release tab ‘J’ in direction shown
and remove fan and housing in same direction.
F
E
D
B
A
C