MJ-4 Communications Module
23
1 Lower Voltage Limit
2 Local Voltage Reduction %
3 VRC Stage1
4 VRC Stage2
5 VRC Stage3
6 Auto VRC1 %I
7 Auto VRC2 %I
8 Auto VRC set1
9 Auto VRC set2
10 Rev Bandwidth Setting
11 Rev Reactive Compensation
12 Rev Resistive Compensation
13 Rev Voltage Level
14 Rev Time Delay
15 Fwd Bandwidth Setting
16 Fwd Reactive Compensation
17 Fwd Resistive Compensation
18 Fwd Voltage Level
19 Fwd Time Delay
20 Voltage Limit Control Enable
21 Voltage Reduction Control Mode
22 Log Setup
23 Alert Status part 1
24 Alert Status part 2
8.2.4 Small 2.x3
Binary Inputs
Point # Description
0 Tap Pos Known
1 Power Flow Direction
2 Auto Inhibit Status
3 Raise (J) Motor Signal
4 Lower (K) Motor Signal
5 Remote Control occurring
6 U2/P2 Switch Position
7 Neutral (U12) Signal
8 Operations Count (U10) Signal
9 Auto Inhibit Terminal Block Input
10 VRC1 contacts
11 VRC2 contacts
12 Remote Switch position
13 Manual Switch position
14 Auto Inhibit Out Status
Binary Outputs
Point # Description
0 Tap Raise
1 Tap Lower
2 Auto Inhibit (Latch On/Off)
Analog Inputs
Point # Description
0 Op Count Last Year
1 N/A
2 R/A/M switch position
3 Power Flow Direction Indicator
4 VRC contacts status
To Next Page
Loading...
