Read Mass Storage
Read a mass storage device (USB mass storage device or SD card) available on
the NK823x unit. Right-click the icon of the connected mass storage device (the
icons display in the box on the right) to display the available commands:
⚫ Show info: Display information about the connected mass storage device.
⚫ Unmount: Command needed to safely remove the mass storage device.
⚫ Set as Log storage: Set the selected device (USB mass storage device or SD
card, if both are available on the system) as the active storage device.
Set Default Log
Restore the NK823x log settings as set in Composer.
Protocol Info
Open the NK Protocols window, which allows configuring the NK823x logging on
the fly (see Using log files [➙ 71]).
Read Logging Status
Read the NK823x logging status: Active, Inactive, Active (Modified) after on-the-fly
configuration changes have been set.
Read Firewall Status
Read the NK823x firewall status: Enabled, Disabled.
Read Routing Status
Read the NK823x routing status: Enabled, Disabled.
9.3.4 Uploading diagnostic files
Diagnostic file purposes
The purpose of these files is to record messages of what has occurred to the
NK8000 to make it easier to determine any issues, or if something important has
happened.
Diagnostic file description
DIAGNO.LOG
This file is always present, and contains detailed technical information about the
behaviour of the software application running on the NK8000. For example, if it was
not possible to open an internal queue during the initialization phase, that message
is saved into this file.
To Next Page
Loading...
