Siemens OpenStage 10 T - Basic Functions; Answering Calls; Answering a Call Via the Handset

Basic functions
15
Step by Step
Basic functions
Answering calls
Your OpenStage phone rings with the tone signal set
when an incoming call is received.
• When you receive an internal call, your telephone
rings once every four seconds (single-tone se-
quence).
• When you receive an external call, your telephone
rings twice in rapid succession every four seconds
(dual-tone sequence).
• When you receive a call from the entrance tele-
phone, your telephone rings three times in rapid
succession every four seconds (triple-tone se-
quence).
• If a call is waiting, you hear a short tone (beep) every
six seconds.
Answering a call via the handset
The phone is ringing.
^ Lift the handset.
if nec.
+ or - Set the call volume. Keep pressing the key until the de-
sired volume is set.
Please read the introductory chapter "Getting to
know your OpenStage phone" Æ page 10 care-
fully before performing any of the steps de-
scribed here on your phone.
Your service personnel can adjust the ring ca-
dence for external and internal calls for you.
In other words, different ring cadences can be
set for different internal callers.