Enhanced phone functions
117
Step by Step
Beep on auto-reconnect
You can reconnect a held call both via the CTI applica-
tion and via the phone. A beep sounds when you toggle
between an active call and a held call when the function
is active.
z
You can also configure this setting via the Web interface
 page 271.
Prerequisite: The option was programmed by your ad-
ministrator.
v Press the key shown until the "Settings" tab is active.
Confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
User
Configuration
Incoming calls
CTI calls
AutoReconnect beep
Yes
Save & exit
To Next Page
Loading...
Need help?
General