Description of functions Alphabetical Reference
75
LAN Port Settings
• The PC port settings can be configured only for the optiPoint 410 stand-
ard/advance.
• Here you must define the bandwidth at which the optiPoint 410 should
be run. The required value depends on the bandwidth that the switch
or router supports in the network.
• A restart is necessary after the change.
Æ page 25 Æ page 58
Language
• Can be configured only for the optiPoint 410 standard/advance.
• Select the language that should be used for local applications here.
• Standard value Æ page 95.
Æ page 32 Æ page 57
Layer 2 Priority
• Can be defined only if the Æ Layer 2 support is activated (Æ QoS L2/
L3).
• A priority value between 0 and 7 can be entered for each of the 64
places (priority 7: highly, 0: low).
• This additional information decide during communication with a
Æ Switch about the priority forwarding.
• Standard value Æ page 95.
Æ page 22 Æ page 58
LDAP Server IP Address
• Can be configured only for the optiPoint 410 standard/advance.
•If an Æ LDAP server is being used, enter the Æ IP address of this serv-
er here.
• IP editor in optiPoint 410 Æ page 94.
Æ page 27 Æ page 56
Bandwith Possible application
10 Mbit/s half dup in 10 Mbit networks with half dup
1
process
1 Up to a date, the data can only be transmitted or received.
10 Mbit/s full dup in 100 Mbit networks in full dup
2
process
2 Up to a date, the data can be simultaneously transmitted and received.
100 Mbit/s half dup in 10 Mbit networks with half dup
1
process
100 Mbit/s full dup in 100 Mbit networks in full dup
2
process
Automatic in standard case
To Next Page
Loading...
