EasyManua.ls Logo

Siemens optiPoint 420 standard - Fixing Problems; Telephone Maintenance; Echo Effect; Troubleshooting

Siemens optiPoint 420 standard
137 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fixing Problems
121
Fixing Problems
Telephone Maintenance
Always use a damp or antistatic cloth to clean the telephone. Never
use a dry cloth.
If the telephone is very dirty, clean it with a diluted neutral cleaner con-
taining surfactants, such as a dish detergent. Afterwards remove all
traces of the cleaner with a damp cloth (using water only).
Never use cleaners containing alcohol, cleaners that corrode plastic, or
abrasive powders.
Echo Effect
Echoes can occur - sometimes quite distinctly - in the course of a tele-
phone call. This effect is not caused by a product or design fault in your
telephone but rather by the other party's telephone.
Troubleshooting
Pressed key does not respond:
Check whether the key is stuck.
Telephone does not ring:
Check whether the do not disturb function was activated on your tele-
phone (" Do not disturb" appears on the screen). If so, deactivate it
Æ Page 74.
You cannot dial an external number:
Check whether you telephone is locked ("US:Not authorized UK:Access
denied" appears on the screen). If so, unlock the telephone Æ Page 78.
To correct any other problem:
First contact your service personnel. If your service personnel is unable to
correct the problem, contact Customer Service.

Table of Contents

Other manuals for Siemens optiPoint 420 standard

Related product manuals