Siemens optiPoint 420 standard - Assigning a Procedure (Operating Steps) to a Key

Saving Functions, Procedures and Appointments
67
Step by Step
Assigning a Procedure (Operating
Steps) to a Key
Station numbers and functions which require additional
inputs, i.e. comprise several operating steps, can be
saved to a single key on your telephone.
Using the associated dial function, for example
Æ Page 51, you can save all the remaining inputs re-
quired (station number of the calling party + the station
number to be dialed) to a single key.
Station numbers which require additional inputs but
also dial pauses can also be stored.
Press the key. The LED lights up.
Select and confirm.
or
qme
Enter the code.
Press the key. If a function has already been assigned to
this key, a corresponding message is displayed.
Confirm.
Confirm.
o
Enter the procedure, e.g. "*67 231 089123456".
*67= code for associated dial
231= station number of the calling party
089123456 = number to be dialed.
If necessary
To insert pauses, press this key (a "P" is displayed).
Confirm.
or If you make a mistake:
Select and confirm. This deletes all digits entered.
If applicable
Select and confirm to update automatic key labeling.
For more information, see Æ Page 117.
Confirm.
*
91=Prog. feature key?
US: Change feature?
UK: Change key?
Procedure key?
US: Save entry?
UK: Save?
Previous?
Key label?
US: End?
UK: Exit?