Siemens optiPoint 420 standard - Making Calls - Basic Functions; Answering Calls; Answering a Call With the Handset; Answering a Call with the Speaker

Step by Step
Making Calls – Basic Functions
14
Making Calls – Basic Functions
Answering Calls
Special default ring signaling is set for your telephone:
• When you receive an internal call, your telephone
rings once every four seconds (single-tone sequence).
• When you receive an external call, your telephone
rings twice in rapid succession every four seconds
(dual-tone sequence).
• When you receive a call from the entrance telephone,
your telephone rings three times in rapid succession
every four seconds (triple-tone sequence).
• If a call is waiting, you hear a short tone (beep) every
six seconds.
The number or the name of the caller appears on the
display.
Answering a Call With the Handset
The telephone rings. The caller appears on the screen.
n
Lift the handset.
u or v
Raise or lower the volume. Keep pressing the key until
the desired volume is set.
Answering a Call with the Speaker
(Speakerphone Mode)
The telephone rings. The caller appears on the screen.
Press the key. The LED lights up.
Speakerphone mode.
u or v
Raise or lower the volume. Keep pressing the key until
the desired volume is set.
Ending the call:
Press the key. The LED goes out.
This function is not available with
optiPoint 420 economy/economy plus.