Siemens OPTIPOINT 500 - Call Forwarding and Mailbox

optiPoint 500 with Display – HiPath 500/1220/3000/5000 RSM/AllServe Important Operating Procedures
26
%
Telephone setup
Change ringer volume
Q or R
Q or R higher/lower vol.
Save QR together
Change ringer pitch
Q or R
Q or R higher/lower vol.
Save QR together
Change call volume
O
Q or R higher/lower vol.
Save QR together
Consultation
Call second user
O
1st user call
K
2nd user call no.
End consultation
Toggling
Alternating calls with
two users
O
Callback conversation
Ring/Ringer volume?
Ring/Ringer tone?
Consult/Enquiry?
Release and return?
Toggle/Connect?
Transferring a call
O
1st user call
K
2nd user call no.
Call may be announced
P
Conference
O
1st user call
K
2nd user call no.
Conf. may be announced
Call forwarding
Activate
K
Call no.
Deactivate
Using callback
Called party is busy
or does not answer
Delete
a) not for HiPath 1220
Consult/Enquiry?
Start conference?
Conference?
Forwarding on?
1=all calls?
a)
Save entry
Forwarding off?
Callback/Set Callback
View callbacks?
Delete?
Using mailbox*
Callback or message
is saved
or
Follow user prompts!
Save call no. on a key
poss.
a)
K
Call no.
Deactivate microphone
Call partner not permitted
to listen in
Activate
Open listening
Activate speaker
Deactivate speaker
View/Display messages?
Message sent/Text?
Call voice mail?
Program/Service
*
91=Prog. feature key?
Second level
Change key/feature?
Repdial key?
Save/Save entry?
Mute
Mute
Speaker
Speaker
oi.book Seite 26 Dienstag, 21. Oktober 2003 8:20 08