Siemens PERFECT HARMONY GENIII/E Series - Page 71

Perfect Harmony GENIII/e User’s Manual The Keypad and Display Interface
A1A19000405A: Version 1.3 3-35
s
s
ss
3
Table 3-19: Sync Transfer Menu (2700)
Table 3-20: External I/O Menu (2800)
Parameter ID Units Default Min Max Description
Phase I gain 2710 2.0 0.0 15.0
Integral gain of the phase loop used dur-
ing Up transfer.
Phase P gain 2720 4.0 1.0 12.0
Proportional gain of the phase loop used
during Up Transfer.
Phase offset 2730 deg 2.0 -90.0 90.0
Phase offset provided at the input of the
phase loop to adjust phase errors due to
sampling. The typical value is 2 degrees.
Phase error
threshold
2740 deg 1.5 0.0 5.0
Phase error level that is used to determine
if phase lock has been achieved during
Up Transfer.
Frequency
Offset
2750 % 0.5 -10.0 10.0
Frequency offset provided at the input of
the speed loop to force the drive to
Torque limit drive Down Transfer.
Up Transfer
Timeout
2760 sec 0.0 0.0 600.0
If the time taken for Up Transfer exceeds
this value then an Up Transfer Timeout
Fault is generated.
Down
Transfer
Timeout
2770 Sec 0.0 0.0 600.0
If the time taken for Down Transfer
exceeds this value then a Down Transfer
Timeout Fault is generated.
Parameter ID Units Default Min Max Description
Analog Inputs 2810 0 0 24
Sets the quantity of analog inputs in the
attached external I/O.
Analog Outputs 2820 0 0 16
Sets the quantity of analog outputs in the
attached external I/O.
Digital Inputs 2830 0 0 96
Sets the quantity of digital inputs in the
attached external I/O.
Digital Outputs 2840 0 0 64
Sets the quantity of digital outputs in the
attached external I/O.
Wago
™
timeout
2850 sec 0 0 600
Sets the Wago
™
watchdog timeout period.