Perfect Harmony GENIII/e User’s Manual The Keypad and Display Interface
A1A19000405A: Version 1.3 3-55
3
Table 3-48: Security Edit Functions Menu (5000)
Table 3-49: Security Edit Menu Function Descriptions (5010, 5020)
Upon selecting either of these functions, an “Enter Menu ID” prompt is displayed. If the menu number is known, it
may be entered at this point. If the menu number is not known, press the [ENTER] key and the display will default to
the top of the Main Menu (5), allowing the user to scroll to the menu item to be changed.
When the operator reaches the menu item to be changed, he must press the [ENTER] key followed by either a [0] to
disable or a [1] to enable the selected edit feature. An asterisk character (*) appears on the left of the display to
indicate to the menu or submenu is in the security edit mode, and not in normal mode. Press the [Cancel] key to exit
security edit mode.
Parameter ID Type Description
Change
security level
5010 Function
This function is used to change a menu item’s security level. When
active, an “x” will appear as the first character on the second line of
the display. Please scroll past Main(5) into another menu. The
current security level will appear as the last character on the second
line of the display. Press [ENTER] to edit the security level for the
ID that is shown. Choose among levels 0, 5, 7, or 8. See Table
3-49.
Drive running
inhibit
5020 Function
This function is used to change a menu item’s run inhibit. When
active an “x” will appear as the first character on the second line of
the display. The current run inhibit state will appear as the last
character on the second line of the display.See Table 3-49
ID Name Description
5010
Change Security
Level
Level = 0,5,7,8
“Change security level” prohibits access to menu or menu items until
“enter security level” is set to that level or higher.
Sets the level of security on that particular menu item.
5020
Drive Running
Inhibit
1 = enable
0 = disable
Prohibits certain parameters from being changed when drive is in the
Run State (D).
Drive running lockout will not allow the parameter to be changed while
the drive is running. “0” indicates that a parameter may be changed
while the drive is running. “1” indicates that a parameter may
not be
changed while the drive is running.
CAUTION! Do not change the Drive Running Inhibit (5020) setting of any parameter unless you are
COMPLETELY certain that the change is safe. Changes may result in massive environmental and
property destruction, injuries, and/or loss of life.
To Next Page
Loading...
