Address Assignment and Installation
3.3 Installing
ET 200S Distributed I/O System - Fail-Safe Modules
Installation and Operating Manual, 08/2008, A5E00103686-07
31
3.3 Installing
Installing the fail-safe modules
The fail-safe power modules, electronic modules, and terminal modules are part of the ET
200S range of modules. They are installed using the same procedure as for all standard
modules in an ET 200S.
Detailed information about module installation is available in the
ET 200S Distributed I/O
System
Operating Instructions.
Installation dimensions
Note that fail-safe modules are 30 mm wide (twice the width of standard ET 200S modules).
Otherwise, the information provided in the
ET 200S Distributed I/O System
Operating
Instructions applies.
To Next Page
Loading...
Need help?
General
