Siemens POLYMOBIL III - Checking the Filament and Tube Current

6 - 1
Siemens AG RXB8-115.034.02 Page 1 of 2 POLYMOBIL III
Medical Solutions Rev. 03 04.05 CS PS 24
D
r
af
t
Start-up report 6
POLYMOBIL III Start-up report 6
The Start-up report is arranged analogously to these Start-up instructions.
Article number / type number / serial number: . . . . . . . . . . . . . . . .
Customer: . . . . . . . . . . . . . . . . . . . . Customer number: . . . . . . . . . . . . . . .
1. Check of the nominal line voltage . . . . . . . . . .V
AC
Instrument type: . . . . . . . . . . . . . .
Serial No.: . . . . . . . . . . . . . .
Calibrated up to: . . . . . . . . . . . . . .
2. Adaptation of the nominal line voltage at >
240 V
AC
on T1
n.a. ok
3. Checking the control and display elements ok
4. Checking the weight counterbalance ok
5. Checking the control elements on the double slot diaphragm. ok
6. Checking the exposure release with high-voltage ok
7. Coincidence of light field and radiation field ok
ΣX: . . . . . . . . . . . cm
ΣY: . . . . . . . . . . . cm
8. Checking the exposure switch-off. ok
9. Protective conductor test
(measured values in separate report
’Protective conductor resistance / report’)
ok
10. Device leakage current measurement
(measured values in separate report
’Device leakage current / report’)
ok
Date: . . . . . . . . . . . . . . Engineer . . . . . . . . . . . . . . . .