Siemens RUGGEDCOM RMC30 Technical Guidance Notes

Technical Guidance Notes
Page 18 of 29 ©2007 Siemens Protection Devices Limited
Figure 19 – RMC30 Browser Interface – Serial Port 1 Configuration Page
Set the protocol to MODBUS Server, type to RS485, and Baud Rate, Parity etc. to appropriate values.
Click Apply to save the changes, note the confirmation message. Click Back to return to the Main
Menu.
From the Main Menu Serial Protocols tree click Configure Device Address Table to open the page.

Siemens RUGGEDCOM RMC30 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RMC30
Category	Server
Language	English