Siemens RUGGEDCOM RS910 Installation Guide

RUGGEDCOM RS910
Installation Guide
Chapter 3
Communication Ports
Fiber Optic Ethernet Ports 17
Section3.2
Fiber Optic Ethernet Ports
Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
Port Types
21
Figure12:MTRJ Port
1.Tx Connector 2.Rx Connector
21
Figure13:LC Port
1.Tx Connector 2.Rx Connector
21
Figure14:SC Port
1.Tx Connector 2.Rx Connector
21
Figure15:ST Port
1.Tx Connector 2.Rx Connector
LEDs
Each port features an LED that indicates the link/activity state of the port.
State Description
Yellow (Solid) Link established
Yellow (Blinking) Link activity
Off No link detected
Specifications
For specifications on the available fiber optic Ethernet ports, refer to Section4.4, “Fiber Optic Ethernet Port
Specifications” .

Siemens RUGGEDCOM RS910 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RS910
Category	Switch
Language	English