HVAC Products CC1B7865en 05.12.2002 11/57
3. Installation
The front can be cleaned with normal washing and rinsing agents or detergents.
G
The front is not resistant to corrosive acids, caustic solutions and abrasive
cleaners. Do not clean with high-pressure cleaners!
The controller module can be removed from the housing for service.
The rules as per DIN EN 100 015 «Protection of electrostatically sensitive
devices » must be observed for internal work on the controller! No liability will
be assumed for damage caused by electrostatic discharge.
7865z09/0200
٭
Press the ribbed surfaces together (at top and bottom) and pull out the controller
module.
3.5. Cleaning the front
3.6 Removing the controller module
To Next Page
Loading...
