Siemens RWF40.002B97 - Parameter Level; Entering Parameters; Configuration Level; Changing the Configuration Code

HVAC Products CC1B7865en 05.12.2002 35/57
6. Operation
The parameters involved in adapting the controller to the controlled system are set here
after the system has been started up.
Within the level, you can proceed to the next parameter by pressing
PGM
.
F
The display of the individual parameters depends on the type of controller.
Entry and alteration of the parameters is made through continuous alteration of the
value. The longer you keep the button pressed, the faster the rate of change.
٭ Increase value by pressing
=
٭ Decrease value by pressing >
٭ Accept entry by pressing
PGM
or
٭ Cancel entry by pressing
EXIT
F
After 2 seconds, the set value will automatically be accepted. The value can
only change within the permissible value range.
ð Chapter 7 «Parameter settings»
The settings made here are those required for commissioning a specific installation and,
therefore, need hardly ever be altered later on (acquisition of measured value or type of
controller).
Within the level, you can advance to the next parameter by pressing
PGM
.
٭ Select position by pressing
> (position flashes!)
٭ Alter value by pressing
=
٭ Accept code by pressing
PGM
or
٭ Cancel entry by pressing
EXIT
ð Chapter 8 «Configuration»
6.3 Parameter level
6.3.1 Entering parameters
6.4 Configuration level
6.4.1 Changing the configuration code