Siemens S7-1500 - Connecting components

Connecting
4.3 Connecting components
SIMATIC TOP connect for S7-1500 and ET200MP
22 Manual,
4.3
Connecting components
Introduction
WARNING
Risk of electrocution
Touching live parts can result in death or serious injury.
Before you connect a module, make sure that it is disconnected from the power supply.
The procedure for connecting the front connector modules is basically the same as for the
standard front connectors. The connection of standard front connectors is described in detail
in the S7-1500 system manual under "Connecting"
(http://support.automation.siemens.com/WW/view/en/59191792
).
Before connecting the front connector modules, read the following sections of the S7-1500
system manual:
● Wiring front connectors for I/O modules without shield connection element
● Preparing and wiring front connectors for I/O modules without shield connection element
● Wiring front connectors for I/O modules with shield connection element
● Preparing front connectors for I/O modules with shield connection element
● Bringing the front connector into final position