Siemens S7-1500 - Purpose of this documentation; Basic knowledge required; Scope of this documentation; Conventions

SIMATIC TOP connect for S7-1500 and ET200MP
Manual,
3
Preface
Purpose of this documentation
This documentation provides important information on wiring the I/O modules (input and
output modules) of the S7-1500 SIMATIC controller and the ET 200MP modular I/O system
with SIMATIC TOP connect system cabling.
Basic knowledge required
General knowledge about automation is needed to understand this documentation.
Scope of this documentation
This documentation applies to all SIMATIC products in the S7-1500 product family with
ET 200MP.
Conventions
Please also observe the notes marked as follows:
Note
A note contains important information about the product described,
about handling the
product or about a specific section of the documentation that requires particular attention.
Recycling and disposal
The products can be recycled as their components are low in pollutants. For the
environmentally friendly recycling and disposal of your old device, please contact a
certificated disposal service for electronic scrap.
Additional support
● You will find information on the technical support service in the appendix to this
documentation.
● The technical documentation for the various SIMATIC products and systems is available
on the Internet (http://www.siemens.com/simatic-tech-doku-portal
).
● You will find the online catalog and online ordering system on the Internet
(http://mall.automation.siemens.com
).