Siemens S7-1500 - Connecting the Connecting Cable to the Terminal Module

Connecting
4.3 Connecting components
SIMATIC TOP connect for S7-1500 and ET200MP
Manual,
31
4.3.4
Connecting the connecting cable to the terminal module
Introduction
This section details how to wire the terminal modules.
Note
Please also follow the instructions in the section
Wiring SIMATIC TOP connect to the
I/O modules
(Page 33). These include the selection criteria for the terminal modules and
information on wiring.
Terminal module function
The terminal module is the interface between the connection cables from the field and the
SIMATIC S7-1500 or ET200MP. The supply voltage cables for the I/O modules can also be
connected to the terminal module.
Fitting the terminal module and connecting cable
1. Fasten the terminal module to a 35 mm standard mounting rail (DIN EN 60715).
2. Connect the connecting cable to the terminal module as shown in the figure below.
Figure 4-8 Connecting the connecting cable to the terminal module
See also
Wiring SIMATIC TOP connect to the I/O modules (Page 33)