Siemens S7-1500 - Connecting the actuators;sensors to the terminal module; Labeling terminal modules

Connecting
4.4 Labeling terminal modules
SIMATIC TOP connect for S7-1500 and ET200MP
32 Manual,
4.3.5
Connecting the actuators/sensors to the terminal module
The connecting cables of the actuators/sensors are connected to the terminals of the
terminal module. Terminal modules are available with the following types of terminal:
● Screw-type terminal
● Push-in system
4.4
Labeling terminal modules
Introduction
The terminal modules are identified using labels. The labels are perforated and are attached
to the front flap of the terminal module.
The following types of labels are available:
● For terminal modules in S7-1500 design
Preparing and attaching labels
1. Tear out the completed label.
2. Insert the label into the holder
① on the outside of the front flap.
Figure 4-9 Label holder with labels (example)