Wiring SIMATIC TOP connect to the I/O modules
5.5 Shield connection of the signal cables
SIMATIC TOP connect for S7-1500 and ET200MP
46 Manual,
2. Push the shield plate up against the terminal module and up.
Figure 5-2 Position shield plate and push up
3. Check that the latch ① has fully engaged.
The latch holds the shield plate in the correct position.
Figure 5-3 Shield plate with latch engaged
4. Mount the terminal module with attached shield plate on the standard mounting rail.
The shield plate connects the terminal module to the grounded mounting rail.
5. Position the shield of the signal cables with the shield connection terminals on the shield
plate.
To Next Page
Loading...
