Siemens S7-200 - Page 120

Operating Your Text Display (TD) Device
5.6 Performing Typical or Routine Operator Tasks
Text Display (TD) User Manual
120 System Manual, 08/2008, A5E00765548-03
● Setting the time in the S7-200 CPU (Set Time and Date)
● Selecting a language set for the TD device (Set Language) (TD 200, TD 200C, and
TD400C)
'LVSOD\$ODUPV
2SHUDWRU0HQX
'LDJQRVWLF0HQX
5HOHDVH3DVVZRUG
&386WDWXV
6HW7LPHDQG'DWH
6HW/DQJXDJH
Figure 5-10 Operator Menu for TD 200, TD 200C, and TD400C
Viewing the Status of an S7-200 CPU
The CPU Status command allows you to display the following information:
● Model and version of the S7-200 CPU
● Error messages generated by the S7-200 CPU
After you select the CPU Status command, the TD device displays the CPU model and
version.
Press the UP or DOWN arrows to display the error messages that were generated by the
S7-200 CPU.
The TD device displays an error message only if an error exists in the S7-200 CPU. The
CPU classifies errors as either fatal errors or non-fatal errors.
'LVSOD\$ODUPV
&386WDWXV
6HW7LPH
5HOHDVH3DVVZRUG
Figure 5-11 CPU Status Menu for TD 100C
Table 5-2 lists the error messages that can be displayed by the TD devices. Refer to the
SIMATIC S7-200 Programmable Controller System Manual for information about specific
errors.