Siemens S7-200 - Configuring S7-400 Backup with STEP 7 Project

Product Overview
1.6 Installation and Configuration Tasks
Text Display (TD) User Manual
22 System Manual, 08/2008, A5E00765548-03
  
SVL SVL
6&38
$ODUPVDUHVRUWHGE\WKHVHTXHQWLDOSULRULW\WKDW
\RXFUHDWHGZLWKWKH7H[W'LVSOD\ZL]DUG
Ⴠ 7KHILUVWDODUPWKDW\RXFRQILJXUDWHGLVWKH
KLJKHVWSULRULW\
Ⴠ 7KHODVWDODUPWKDW\RXFRQILJXUHGLVWKH
ORZHVWSULRULW\
5HIHUWR&KDSWHUVDQGIRULQIRUPDWLRQDERXW
DODUPV
8VHU0HQX
6FUHHQV
&KDQJH
6L]H
+HLJKW /HQJWK :LGWK
&KDQJH
3UHVVXUH
0D[LPXP 0LQLPXP
7''HYLFH
$ODUPV
3UHVVXUH+LJK
&KHFN6SHHG
&DOLEUDWH6L]H
Figure 1-3 Screens and Alarms
1.6 Installation and Configuration Tasks
Installation and Configuration Tasks
As shown in Figure 1-4, you use the Text Display wizard of STEP 7-Micro/WIN to configure
the TD device. You can create a custom faceplate for the TD 100C, TD 200C, and TD400C.
The Keypad Designer creates a keypad configuration file for the Text Display wizard.
An overview of the tasks for installing your TD device is shown in the figures below. Refer to
Chapter 2.