Text Display (TD) User Manual
System Manual, 08/2008, A5E00765548-03
3
Preface
Scope of this Manual
This manual describes the installation, configuration and operation of the TD 100C version
1.0, the TD 200 version 3.0, the TD 200C version 1.0, and the TD400C version 2.0. This
manual also describes the Text Display wizard of STEP 7-Micro/WIN (used to configure the
S7-200 CPU for the TD devices) and the Keypad Designer application (used to configure the
keypad of the TD 100C, the TD 200C and the TD400C).
To utilize these TD devices, you must use the following:
● STEP 7-Micro/WIN version 4.0 SP2 or greater for TD 100C version 1.0
● STEP 7-Micro/WIN version 4.0 or greater for TD 200C version 1.0 and TD 200 version
3.0
● STEP 7-Micro/WIN version 4.0 SP6 or greater for the TD400C version 2.0
Purpose of the manual
The SIMATIC Text Display (TD) User Manual is a combination user and reference manual
that describes the operation of the TD devices with an S7-200 CPU.
Required Basic Knowledge
This manual is designed for engineers, programmers, and maintenance personnel who have
a general knowledge of programmable logic controllers and operator interfaces.
Recycling and Disposal
Please contact a company certified in the disposal of electronic scrap for environmentally
safe recycling and disposal of your device.
Place of this Document in the Information Environment
Table 1 Place of the Text Display User Manual in the Information Environment
Product Family Documentation Order Number
SIMATIC Text Display (TD) User Manual (resides on
the STEP 7-Micro/WIN documentation CD)
Not applicable S7-200
Simplified Chinese Character Set (resides on the
STEP 7-Micro/WIN documentation CD)
Not applicable
S7-200 S7-200 Programmable Controller System Manual 6ES7 298-8FA24-8BH0
To Next Page
Loading...
