Installing your Text Display (TD) Device
2.4 Mounting the TD 100C in a Panel or on a Surface
Text Display (TD) User Manual
System Manual, 08/2008, A5E00765548-03
35
Mounting the TD 200, TD 200C, and the TD400C
Refer to Figure 2-3 and use the following procedure to complete the mounting of your TD
device:
1. Remove the gasket from the protective cushion.
2. Place the supplied gasket on the frontplate of the TD device.
3. Install the spacers (if required).
4. Fit the frontplate into the cutout you made in the mounting surface.
5. Secure the backplate onto the frontplate of the TD device using the screws you removed
from the backplate. Carefully tighten the screws until snug.
2.4 Mounting the TD 100C in a Panel or on a Surface
Mounting the TD 100C in a Panel or on a Surface
Preparing the Mounting Surface for a TD 100C
To prepare the surface where the TD 100C is to be mounted or installed:
● Cut a 69 mm x 82 mm hole in the mounting surface (DIN 43700)
● Refer to Table A-1 for the outside dimensions of the TD 100C device.
69 mm
82mm
Figure 2-4 Dimensions for Cutting a Hole in the Mounting Surface of the TD 100C
To Next Page
Loading...
