Siemens S7-200 - Page 37

Installing your Text Display (TD) Device
2.5 Customizing the Labels for the Keys of the TD 200
Text Display (TD) User Manual
System Manual, 08/2008, A5E00765548-03
37
5. Reinstall the front cover into the back housing.
6. Replace and tighten the three screws on the back of the TD device to ensure that the
cover and housing are secure.
7DERIODEHOLQVHUW
8VHWZHH]HUVWRJUDVSWKHWDERIWKHODEHOLQVHUW
Figure 2-6 Removing the Label Insert
Creating a Custom Label Insert for the TD 200
The dimensions for creating your own custom label insert are shown in the figure below.
These dimensions are valid for TD 200, hardware revision 3 and later.
PP
PP PP
PP PP
PP PP PP
PPPP
PP
PP
PP
PP
PP
PP
PP
PP
PP
PP
PP
PP
PP
PP
PP
PP
0DWHULDOWKLFNQHVVPP
:LQGRZRQWKHIDFHSODWHWKDWDOORZV
\RXWRDGGWH[WIRU\RXU7'
Figure 2-7 Dimensions for a Custom Label Insert