Configuration Using Web Based Management and the Command Line Interface
C79000-G8976-C184-07
109
In HiPath Access Point mode, the following restrictions apply
-PLUG possible
and no redundancy p
No iPCF possible.
• Heavy data traffic in g from voice) can impair the
quality of the individ for example, S7 communication).
This means that a re ed.
Note
• No use of the C
• No WDS ossible.
•
the cell (for example, resultin
ual wireless connections (
sponse time cannot be defin
The following table sho the HiPath access point
AP2600 and the SCAL RR in the HiPath Access Point mode:
HiPath AP2600
ALANCE W788-2RR in
ath Access int mode
ws the significance of the LEDs of
ANCE W788-2
SC
HiP Po
LED Color
LED
(meaning)
Color
- - -
Yellow/green
P1
(Ethernet port)
- - -
ernet)
Green
L2
(power supply Eth
5 GHz Green Green R1
2.4 GHz Green Green R2
Middle Yellow Yellow R1 + R2
- - -
Green
L1
(power supply M12)
Middle Red
Red
F
(fault)
For the arrangement of the LEDs on the device, refer to Figure 2-1 "The LEDs of
the SCALANCE W78x".
For information on the other steps in configuration, refer to the manual HiPath
Wireless Controller, Access Points and Convergence Software - User Guide.
Exiting the HiPath Mode
If you want to return the Scalance W access point to the standard modes "Access
Point" or "Client Mode", the HiPath firmware must be deleted in RAM. To do this,
turn of the power to the Scalance W AP for at least 30 seconds. Following this, the
AP starts up again with the SCALANCE W firmware and it is now possible to
change the mode over the Web interface.
Operating Instructions SCALANCE W78x
To Next Page
Loading...
