Configuration Using Web Based Management and the Command Line Interface
C79000-G8976-C184-07
118
d
System Ev
ge, you spec 78x reac s. You
can configure the reaction of the SCALANCE W78x to the
Startup of the SCA
Change in the Ethe wn.
● Error in authentication.
● Changing the power supply of the SCALANCE W78x. nt
is only useful when using a redundant power supply.
Change in the erro
If you use the SCALAN t, you nal
● IP-Alive state chan ction
● Link Check state ch e-specific connection monitoring)
● Events related to bandwidth reservation iQoS
● Authentication of the client
● Detection of access points on own or an overlapping wireless channel.
● Topology changes in Rapid Spanning Tree.
● For the SCALANCE W788-1RR and SCALANCE W788-2RR models, events in
conjunction with iPCF.
● Events in conjunction with the Forced Roaming on IP down function .
● Change in the WDS connection status Link up / Link down.
With the SCALANCE W788-2PRO and SCALANCE W788-2RR models, there is
also the status of a redundant connection (redundant, not redundant, interrupted)
as a system event.
6.2.5 Event Config Menu Comman
ents of the SCALANCE W78x
On this pa ify how the SCALANCE W ts to system event
following events:
● LANCE W78x
● rnet status Link up / Link do
Evaluation of this eve
● r status
CE W78x as an Access Poin can configure additio
system events:
ge (application-specific conne
ange (devic
monitoring)
Operating Instructions SCALANCE W78x
To Next Page
Loading...
