Configuration Using Web Based Management and the Command Line Interface
6.2.4 Restart Menu Command
C79000-G8976-C184-07
116
an leave the browser
estore M lts button
defaults) are not reset:
● IP address
● Subnet mask
● SSID
address of the default router
● System location
m contact
If you are logged on as user, the Restore Memory Defaults button is not visible.
Restart button
Click this button to restart the SCALANCE W78x. During a restart, the
SCALANCE W78x is reinitialized, the internal firmware is reloaded, and the
SCALANCE W78x runs a self-test. The entries that have been learned in the
address table of the SCALANCE W78x are deleted. You c
window open while the SCALANCE W78x restarts.
R emory Defau
Click this button to reset the configuration. The following parameters (protected
● Gateway address
● IP
● DHCP flag
● System name
● Syste
● Device mode
● Country code
There is no automatic restart. This allows you to enter data using Web Based
Management before the restart. The changes take effect only after a restart.
Operating Instructions SCALANCE W78x
To Next Page
Loading...
