Configuration Using Web Based Management and the Command Line Interface
C79000-G8976-C184-07
147
Syntax of the Command Line Interface
CLI\INTERFACES\WLAN1>
or for the second wireless adapter (if it exists)
C S\WLAN2>
mmand
LI\INTERFACE
Co Description Comment
port [E|D]
able wireless port. Enable / dis
ssid [network name]
Assigns a network name (SSID).
Available only in the
access point mode.
mode [A|B|G|H|T|U|X]
Selects the transmission standard:
A 802.11a
B 802.11b
G 802.11g
H 802.11h
T 802.11a Turbo
U 802.11h Turbo
X 802.11g Turbo
Depending on the country
code, some settings are
not possible and will then
be rejected.
802.11a Turbo cannot be
set in all countries.
autoch [E|D]
able the channel
ALANCE W78x.
Available only in the Enable / dis
selection by the SC access point mode.
channel [1...167]
channel. Specifies the wireless
altchan [channel]
er of the
nnel.
11h Enters the channel numb
alternative DFS cha
Possible only in 802.
transmission.
adopt [MAC address]
e vailable only in the client
ode.
MAC address of the devic
connected to the client over
Ethernet.
A
m
autoadopt [E|D|OWN|L2T]
MAC
nnected to
rnet.
The OWN parameter means that the
client registers with the access point
with its own Ethernet MAC address.
With this setting, however, only IP
data traffic is possible.
vailable only in the client
ode.
Automatic adoption of the
address of the device co
the client over Ethe
A
m
adhoc [E|D]
Select ad hoc or infrastructure
mode.
Available only in the client
mode.
anyssid [E|D]
With ANY SSID, the client connects
to the best access point in the
environment in which it is permitted
to connect.
Available only in the client
mode.
vapno [0...7]
Specifies the number of virtual
access points
outdoor [E|D]
Enable / disable outdoor AP mode
802.11 g
Open the ADVANCED G (802.11g)
menu
ADVANCED
Open the ADVANCED menu
DATARATES
Open the DATARATES menu
VAP1
Open the VAP1 menu
Displayed only when
vapno > 0.
Operating Instructions SCALANCE W78x
To Next Page
Loading...
