Siemens SCALANCE W788-1PRO - Page 154

Configuration Using Web Based Management and the Command Line Interface
C79000-G8976-C184-07
154
e Syntax of the Command Line Interfac
CLI\INTERFACES\WLAN1\ADVANCED>
mmand Description Comment Co
power [0...4
0 Full power
4 Minimum power, -12 dB
]
Specifies by how many dB the
transmit power will be reduced
compared with full power:
1 -3 dB, half
2 -6 dB, quarter
3 -9 dB, eighth
beacon [20 ... 1000]
Specifies the beacon interval in
milliseconds.
dtim [1 ... 255]
Specifies the data beacon rate.
Available only in the
access point mode.
rtsthr [1 ... 2346]
Specifies the packet size as of which
RTS/CTS is used.
fragthr [256
ize as of which
packets are fragmented.
... 2346]
Specifies the s
bkscan [D|I|A]
Specifies the mode in which the
client scans for further access
Available only in the client
mode.
points.
D Disabled
I Scan if idle
A Scan always
bkscanint [200...60000]
Interval at which the client scans for
further access points.
Available only in the client
mode.
bkchannel [channels]
Selection of channels on which the
for further access
The channels are entered separated
anks.
Available only in the client
mode. client scans
points.
by bl
bkchsel [E|D]
Enables / disables sca
further access points
nning for
to specific
nels.
Available only in the client
mode.
chan
force [E|D]
Enables / disables roaming if the
connection is lost on Ethernet
Available only in the
access
interface.
point mode.
roamthr
Decides the threshold at which the
client changes to another AP.
low changes at a
slightly higher
field strength to the AP
with the stronger signal.
medium changes at a
moderately higher field strength
to the AP with the
stronger signal.
high changes at a
significantly higher field strength
to the AP with the
stronger signal.
Operating Instructions SCALANCE W78x