Configuration Using Web Based Management and the Command Line Interface
C79000-G8976-C184-07
200
o for the RSTP value, the value for the path costs is
atically.
check box
ise a
Here, there are three possible settings:
n is selected:
ry ForceFalse in the port table.
corresponds to the entry Auto in the port table.
Point-to-point means a direct connection between two stations. A shared media
connection would, for example, be a connection from the Ethernet port to a hub or
ccess points.
If you enter a zer
calculated autom
Admin Edge Port
Enable this check box if an end device is connected to this port, otherw
reconfiguration of the network will be triggered by every link change.
Admin Point to Point Status check boxes
Shared media Connectio
This corresponds to the ent
Point to Point Connection is selected:
This corresponds to the entry ForceTrue in the port table.
Point to Point Connection and Shared Media Connection are not
selected:
This
Note
a WDS connection between two a
Syntax of the Command Line Interface
C PANNING\PORT
Command Comment
LI\BRIDGE\S S>
Description
info
Displays the current Spanning Tree
configuration for all ports.
portstp <E|D> [ports]
sables the spanning tree
Enables / di
algorithm for the specified ports.
portprio <Port>
[0 ... 255]
Specifies the priority of the port. Default value: 128
stp_cost
[1
<Port>
... 65535]
Specifies the path costs for the port
if Version is set to STP.
Default value: 100
Operating Instructions SCALANCE W78x
To Next Page
Loading...
