7. Close the cover of the connection element.
8. Slide the locking slide forward until it stops.
Result
The cables of the BusAdapter are connected.
4.4.4 Mounting a BusAdapter
Requirement
The cables of the BusAdapter are connected.
Procedure
1. Install the FC cable to the BusAdapter.
2. Plug in the BusAdapter and screw it tight.
3. Secure the PROFINET IO cable to protect the plug from pulling.
Installation
4.4 BusAdapter BA 2xFC
BusAdapter for Distributed I/O
20 Equipment Manual, 10/2021, A5E39261458-AC
To Next Page
Loading...
