2-15
C7-621 / C7-621 AS-i Control Systems
C79000-G7076-C621-01
2.6 Connecting Up Cables
This chapter describes how to connect the shield of shielded signal cables
with ground. The shield is connected directly to the ground terminal of the
C7 via a grounding bar.
Fit the grounding bar and the shield clips supplied with the C7-621 as
follows:
1. Remove the two screws from the C7-621 as shown in Figure 2-11.
2. Position the grounding bar as shown in Figure 2-11 and fasten it in
position with the two screws previously removed.
3. Fit the shield clips on to the grounding bar as shown in
Figure 2-11.
4. Press the stripped cable into the shield clips so that the shield of the cable
makes the best possible contact.
Shield clip
Figure 2-11 C7-621 with Grounding Bar and Shield Clips
Overview
Procedure
Installing and Preparing the C7
To Next Page
Loading...
Need help?
General
