Siemens SIMATIC ET 200AL - 2 xCount Parameter Explanations; General Parameter Explanations (2 xCount)

Counting
4.1 Configuration method 2xCount
Digital input/Digital output module DIQ 16x24VDC/0.5A 8xM12 (6ES7143-5AH00-0BA0)
38 Manual, 03/2019, A5E38688112-AC
Parameter
Value range
Default
Scope
Behavior Counter 0 (DI4), Counter 1 (DI6)
Behavior DI
• Digital input without func-
tion
• Gate start/stop (level-
controlled)
Digital input without
function
Counter
Behavior Counter 0 (DI5), Counter 1 (DI7)
Behavior DI
• Digital input without func-
tion
• Counting direction
Digital input without
function
Counter
Input delay DI
• 0.05 ms
• 0.1 ms
• 0.4 ms
• 0.8 ms
• 1.6 ms
• 3.2 ms
• 12.8 ms
• 20 ms
3.2 ms Counter
1
= Is ignored if DI5/DI7 is parameterized as the direction input.
2
= Cannot be parameterized with GSD file
The table below shows the parameters of the freely assignable Channels 8...15.
Table 4- 9 Parameter freely assignable Channels 8..15
Parameter
Value range
Default
Scope
Freely assignable channel
• DI
• DQ
DI Channel
Substitute value channel
• 0
• 1
0
Channel
(digital out-
puts)
Input delay
• 1.6 ms
• 3.2 ms
• 12.8 ms
• 20 ms
3.2 ms Channel
(digital inputs)
See also
Pin assignment (Page 33)