Siemens SIMATIC ET 200AL - Pin Assignments (DIQ Modes); DIQ and DIQ with Value Status Pinout

Configuration modes for digital inputs/outputs
3.2 Wiring
Digital input/Digital output module DIQ 16x24VDC/0.5A 8xM12 (6ES7143-5AH00-0BA0)
16 Manual, 03/2019, A5E38688112-AC
3.2.2 Pin assignment
Note
Color coding
The sockets for ET
-Connection and the power supply of the modules are color-
coded. These
colors correspond to the colors of the offered cables.
NOTICE
24 V encoder supply 1U
S
/ 2U
S
Use only the 24 V encoder supplies 1U
S
and 2U
S
provided by the digital input/digital output
module to supply power to the encoder.
Pin assignment of the sockets for digital inputs/digital outputs in the configuration modes DIQ and
DIQ with value status
The tables below show the pin assignments of the 8 sockets for connection of the digital
inputs/digital outputs.
Table 3- 1 Pin assignment for digital inputs/digital outputs
Pin
Assignment
Front view of the sockets
X10 to X13 sockets for digital inputs / outputs
X10, X12
X11, X13
1 24 V encoder supply 1U
S
(derived from 1L+ non-switched)
2 Input/output signal DIQ
1
: Connector X10
Input/output signal DIQ
3
: Connector X11
Input/output signal DIQ
5
: Connector X12
Input/output signal DIQ
7
: Connector X13
3
Ground 1M
4 Input/output signal DIQ
0
: Connector X10
Input/output signal DIQ
2
: Connector X11
Input/output signal DIQ
4
: Connector X12
Input/output signal DIQ
6
: Connector X13
5
Functional earth FE