Siemens SIMATIC ET 200AL - 4 xCount Connection Pinouts; Digital I;O and ET-Connection Pinouts (4 xCount)

Counting
4.2 Configuration method 4xCount
Digital input/Digital output module DIQ 16x24VDC/0.5A 8xM12 (6ES7143-5AH00-0BA0)
54 Manual, 03/2019, A5E38688112-AC
The table below shows the pin assignments of the 4 sockets for the connection of the digital
inputs / digital outputs.
Table 4- 17 Pin assignment for digital inputs/digital outputs
Pin
Assignment
Front view of the sockets
X14 to X17 - sockets for digital inputs / outputs
X14, X16
X15, X17
1 24 V encoder supply 2U
S
(derived from 2L+ switched)
2 Input/output signal DIQ
9
: Connector X14
Input/output signal DIQ
11
: Connector X15
Input/output signal DIQ
13
: Connector X16
Input/output signal DIQ
15
: Connector X17
3
Ground 2M
4 Input/output signal DIQ
8
: Connector X14
Input/output signal DIQ
10
: Connector X15
Input/output signal DIQ
12
: Connector X16
Input/output signal DIQ
14
: Connector X17
5
Functional earth FE
NOTICE
24 V encoder supply 2U
S
Use only the 24 V encoder supplies 2U
S
provided by the digital input/digital output module
to supply power to the encoder.
Pin assignment of the sockets for ET-Connection
The table below shows the pin assignments of the 2 sockets for the connection of
ET-Connection.
Table 4- 18 Pin assignment for ET-Connection
Pin
Assignment
Assignment of the
wire color of the
bus line cable for
ET-Connection
Front view of the sockets
X30 socket
(ET-Connection
IN)
X31 socket
(ET-Connection
OUT)
X30
X31
1 TXP RXP Yellow
2
RXP
TXP
White
3
RXN
TXN
Blue
4
TXN
RXN
Orange
Shield-
ing
Functional earth FE -