Siemens SIMATIC ET 200AL - PROFlenergy Counter Mode Parameter; Mode Parameter Settings for Counter Inputs

PROFIenergy
6.4 Behavior of the digital inputs of the counters
Digital input/Digital output module DIQ 16x24VDC/0.5A 8xM12 (6ES7143-5AH00-0BA0)
84 Manual, 03/2019, A5E38688112-AC
Mode parameter
The following table shows the "Mode" parameter.
Table 6- 3 Mode parameter
Element
Code
Explanation
Mode 0
D
: PE_MODE_PROCEED The counter functions as in the normal count mode.
The count output depends on the count value.
1
D
: PE_MODE_SHUTDOWN The count value is no loner updated.
The count output is set to 0.
3
D
: PE_MODE_LAST_VALUE The count value is no longer updated (the input does
not supply any edges).
The count output contains the last value, since the
count is no longer updated.
4
D
: PE_MODE_SUBST_VALUE The count value is no longer updated (the input does
not supply any edges).
The count output is set to the parameterized substi-
tute value, irrespective of the count value.