Siemens SIMATIC ET 200pro - Page 13

Product overview
2.3 Components of the ET200pro distributed I/O system
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
13
Component
Function
View
Connection module for
the ET 200pro Ether-
Net/IP interface mod-
ule
The connection module is mounted on the
interface module. It is used to connect
EtherNet/IP and the electronic, encoder, and
load voltage supplies.
The following connection module is available
for EtherNet/IP:
• CM IM M12, 7/8" (ZNX:ET200PROCM1)
Power module with bus
module and outgoing
module
① The power module provides a new poten-
tial group for the 2L+ load voltage supply.
The unit is shipped with the power module
mounted on the bus module.
② The outgoing module enables the 1L+
electronics/encoder supply and the 2L+ load
voltage supply to be tapped.