Siemens SIMATIC ET 200pro - 2.6 Configuring (project planning)

The ET 200pro EtherNet/IP module
3.7 Device profile: supported CIP objects
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
35
3.7.4
TCP/IP Interface Object
The TCP/IP Interface Object provides the mechanism to configure the ET 200pro
EtherNet/IP TCP/IP network interface. Examples of configurable items include the device's
IP address, network mask, gateway address, and host name.
Class attributes
1, 2, 3
Class services
0x1, 0xE, 0x
10
Instance attributes
1, 2, 3, 4, 5, 6, 12
Instance services
0x1, 0xE, 0x10
Class attributes for TCP/IP Interface Object
Attribute
ID
Access
rule
Description
Data type
Default val-
ue
1
Get
Revision
UINT
0x0001
2
Get
Maximum number of instances
UINT
0x0001
3
Get
Number of instances
UINT
0x0001
Instance attributes for TCP/IP Interface Object
Attribute
ID
Access
rule
Description
Data type
Default value
Semantics of values
1 Get Interface status
(Status)
DWORD 0x00000002 See table below: "Table for
Interface status, attribute
1"
2 Get Interface capa-
bility flags (Con-
figuration
Capability)
DWORD 0x00000015 Bit 0: BOOTP Client (false)
Bit 1: DNS Client (true)
Bit 2: DHCP Client (true)
Bit 3: DHCP-DNS Update
(false = device is not ca-
pable of sending its host
name in the DHCP re-
quest)
Bit 4: Configuration Setta-
ble (true = Interface control
flags are settable, see
attribute 3)
Bit 5-31: reserved
3 Set Interface control
flags (Configura-
tion Control)
DWORD 0x00000000 Bit 0-3: Startup Configura-
tion (0 – as stored in flash,
1 = via BOOTP, 2 = via
DHCP, 3-15 = reserved)
Bit 4: DNS Enable (false)
4 Get Path to physical
link object
STRUCT
of:
Identifies the object asso-
ciated with underlying
physical communication
object.