Siemens SIMATIC ET 200pro - Firmware Updates

Commissioning
5.6 Firmware updates
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
65
5.6
Firmware updates
You perform firmware updates by using the EIP ET200 Configuration Tool and EtherNet/IP.
See the Configuration Tool User Reference Guide for detailed instructions.
Note
If QuickConnect is turned on in the ET
200pro EtherNet/IP module, you should not perform a
firmware update with the Configuration Tool because the self
-checks are turned off in that
mode.