Product overview
2.2 What is the ET 200pro distributed I/O system?
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
9
What is the ET 200pro distributed I/O system?
The ET 200pro distributed I/O system is a modular distributed I/O system available in
degrees of protection IP65, IP66, and IP67.
A robust design and degree of protection IP65, IP66, or IP67 make the ET 200pro
EtherNet/IP module particularly suitable for use in rugged industrial environments.
With IP65, IP66 and IP67, the ET 200pro EtherNet/IP module is protected against the
ingress of foreign bodies and water. The module does not require an additional enclosure.
The ET 200pro EtherNet/IP module supports communication with:
● Fieldbus
● Fieldbus Data Link Layer
For more information, see the topic "Standards and approvals".
With the ET 200pro system, you can connect virtually any number of I/O modules in virtually
any combination right next to the interface module. This means that you can adjust the
configuration to suit local requirements.
The ET 200pro EtherNet/IP module is installed on a rack and basically consists of the
following:
● An interface module that transfers data to the EtherNet/IP master
● Up to 16 electronic modules with maximum 1 m total width (without rack)
● Connection modules in various designs for
– ET 200pro EtherNet/IP module
– Supply voltages
– Inputs and outputs
● Pneumatic interface modules for linking of FESTO valve terminals
You can thus set the focus of your configuration on local requirements.
The convenient handling features of ET 200pro EtherNet/IP module ensure quick
commissioning and easy maintenance.
Terminal modules and electronic modules
The ET 200pro distributed I/O system consists primarily of various passive connection
modules to which you connect the electronic modules and motor starters.
The ET 200pro EtherNet/IP module enables the ET 200pro distributed I/O system to be
connected to the EtherNet/IP network.
To Next Page
Loading...
