Siemens SIMATIC ET 200pro - 3.2 Installation measurements and clearances

The ET 200pro EtherNet/IP module
3.8 Device profile: vendor-specific objects
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
45
Common services for the Adapter Object
Service
code
Implemented for
Service name
Class
Instance
0x0E
No
Yes
Get_Attribute_Single
0x10
No
Yes
Set_Attribute_Single
3.8.2
Slot Object
The following information applies to the Slot Object for the ET 200pro EtherNet/IP module.
The Slot Object provides the external configuration and monitoring interface to the I/O
module in one slot. One instance of this object exists for each available slot.
Class code
0x65
Class attributes
No attributes are supported for the Slot Object at the class level.
Number of instances
63
Instance attributes of the Slot Object
Attribute
ID
Access rule
Name
Data type
Data value
1 Get / Set
1,2
ModuleRefer-
ence
UINT For Configuration Tool use.
2 Get / Set
1,2
ParameterSize USINT Number of parameter bytes required by this
slot (max. 32).
3 Get / Set
1,2
Parameters Array of
USINT
Parameter bytes for this slot: array size is set
by Attribute 2.
4
Get / Set
1,2
ConfigByte
USINT
Configuration byte for this slot.
5
Get
SlotStatus
USINT
Slot status code (see Attribute 5 table).
6
Get
Channel0Status
USINT
Channel Status code (see Attribute 6-13
table).
7
Get
Channel1Status
USINT
8
Get
Channel2Status
USINT
9
Get
Channel3Status
USINT
10
Get
Channel4Status
USINT
11
Get
Channel5Status
USINT
12
Get
Channel6Status
USINT
13
Get
Channel7Status
USINT